a New Material. The Goal was to Produce A True Isotropic Composite with Chopped Fibers in Complex Shapes that Offerd Mechanical Performance Closer to Prepreg.

　　, then what had previously ben impossible would bersSible. "" "" "" "" ""

　　Count carbon fiber.

　　, Tests Show We & RSquo; Ve Achieved Higher Molded Properties with FMC than With 3K CF-SMC. "

　　Properties & mdash; a feature excerbated by conventional high-flow compression molding.

　　The big challenge was smc molding how to the achieve this. "

　　/Distributed Those Bundles Isotropically Across the Sheet During SMC Compounding.

　　in Mechanical Properties.

　　Ideal acquisition target for mitsubishi. Since then, Gemini has LED FMC Design and Process Development to Ensure Isotropertles Aren & RSquo; T Lost During PROCESING.

　　The Geometry But Also Compensate for Negative Effects Resulting from the Inevitable Material Flow & Mdash; a Far More Complex Approach.

　　An Early FMC Demonstrator was an Automotive Suspension Component ~ 362 x 63 x 70 mm and 3-13 mm thick.

　　so both part and mold are low-flow friendly. ""

　　TOP and Bottom of Deep Ribs. Akiyama Says It Fills Complex Geometry Better than 3K CF-SMC.

　　Of the press.

　　3K CF-SMC, Yet there are also fewer resin-rich areas owing to the excelked well. This enables us to priverties more eConomically.

　　at lower loads.

　　Parts is an explicy application for FMC, "Akiyama adds." SINCE We Can Make a Mold for the Cost of Machine A Few Metal PARTS, if more than a handful of parts are needed, we will be compert.