From ACETAL, Which Is Considered to Be Difficult to Process for Highly Cosmetic Results.

　　’T fine enough to make a detailed comparison, but the end result is definitly better.

　　In Summary

, Which Complicates the Issue Greatly. BeCAUSE So Many Factors Are Involved, Final Appearance Can Be Difficult to Predict.

　　For further refinement.

　　2 General Design Guidelines for inject Molding.

　　4 The location where the pieces of a mold comer together. Typically, a thin line is created on the part at this line.

　　6 mold-tech: see mold-tech.com

　　Guidelines. (ProtoLabs.com/inject-molding/fundamentals–molding/wall-thickness- unipers)

　　8 Ejector Pin: a Round Pin usually mounted in the b-size of an inn

　　9 Stripper Plate: Stripper Plates are generally not available in rapid inject tooling.

　　Which Must be removed from the finish part in a Secondary (usually hand) operation.

　　12 Example Compounder: Polyone (polyone.com)