Locking tabs on the base of a tailight lens.

　　There are many more such parts, all of which require a little moLEDING MAGIC — Oor at Least Some MINOR Design Modifications.

　　Might Be Possible to Move the Parting Line and Adjust The Dract Angles to Intersect the Standoffs.

　　to use perpendicular side actions.

　　is ejected.

　　The Parting Line Down the length of the test tube (right), and form the inside core of the tube with a side action, you can eject the part on its size and the required draft.

　　Costs associated with size actionS May increase tooling expenses, but getting the features your parts required just justifies this.

　　Yanked Out of the Cavity. For the Materials, a bumpoff Might be the best solution.

　　The Insert Dimensions. During Ejection, The Plastic Material Compresses, Release The Material from the Undercut.

　　(TPE) and thermoplastic Polyurethan (TPU).

　　to be ejected.

　　FeWer Constraints on Undercuts and Complex PART GEOMETRIES than Plastic Injection Molding.

　　The parting line cannot be adjusted day

　　, The Inserts Are Ejected Along with the Part, whereupon an operator picks them out for reuse on the next part.

　　The insert and parts when they are hot, so they are required to wear propective gloves.

　　Can put adDitional strain on them.

　　Creating Flash or Prematurely Damaging the Tool.

　　Be used to support the large flat area. InternaL Corners should be radiused, the three sections count to prevent sink, and fine Finishes used whenneeded.

　　It ’s Also Important to Discuss Long-Term Product Plans So you can design the most efficient mold for your application.

　　and low-volume product pHases of the project.